Hw-module Slot R1 Reload
I have a test 7507 with rsp-k4pv-mz.120-32.S8.bin on both RSP2s. I've done
this:
service single-slot-reload-enable
Symptom: The command does not display by 'show run' when reload switch, But I can find it by 'show start-'. hw-module slot x account np 0 out 24 hw-module slot x account np 1 out 24 - Problem description/Trigger: - command 'hw-module slot account np in/out' and 'hw-module slot allow-coexist np ' gets removed when first. The controls for Fortnite and Fortnite: Battle Royale are identical. The game can be played across a variety of platforms, including Mobile, PC/Mac, Xbox One, Playstation 4, and Nintendo Switch. Note that the Mobile and Switch versions have the Battle Royale mode only. 1 Mobile (Default) 2 PC / Mac 3 Playstation 3.1 Building (Builder Pro) 3.2 Combat (Builder Pro) 4 Xbox 4.1 Building (Builder.
Hw Module Slot R1 Reload Entertainment Limited, hereinafter called (bgo.com or the Company). Read our full review. Visit casino -70.-Prize pool: 300% up to €2000.
redundancyno keepalive-enable
mode sso
And it doesn't seem to ever sync the slave
Hw-module Slot R1 Reloaded
ranttest#show red
Redundant System Information : ------------------------------
Available system uptime = 14 minutes, 49 seconds
Switchovers system experienced = 0
Standby failures = 0
Last switchover reason = none
Hardware Mode = Duplex Configured Redundancy Mode = sso
Operating Redundancy Mode = hsa
Maintenance Mode = Disabled
Communications = Down Reason: Simplex mode
Current Processor Information :
-------------------------------
Active Location = slot 2
Current Software state = ACTIVE
Uptime in current state = 13 minutes, 24 seconds
Image Version = Cisco Internetwork Operating System
Software
IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(32)S8, RELEASE SOFTWARE
(fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by cisco Systems, Inc.
Hw-module Slot R1 Reloader
Compiled Mon 20-Aug-07 16:34 by leccese
BOOT =
CONFIG_FILE =
BOOTLDR =
Configuration register = 0x2102
Peer (slot: 3) information is not available because it is in 'DISABLED'
state
ranttest#redundancy force-switchover
Cannot perform switchover until the standby is fully initialized.
The box is up, its got two OSPF adjacencies, maybe a hundred routes - its
not doing anything fancy, so I'm kind of stuck here. The production target
Hw-module Slot R1 Reloadable
is 7507s /w RSP4s, the same OSPF, and about 180k routes via BGP. Any ideawhat might be wrong here?
_______________________________________________
cisco-nsp mailing list cisco-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/